Showing posts with label lights. Show all posts
Showing posts with label lights. Show all posts

Tuesday, April 30, 2013

Car Interior Lights Delay

Most cars do not have delayed interior lights. The circuit presented can put this right. It switches the interior lights of a car on and off gradually. This makes it a lot easier, for instance, to find the ignition keyhole when the lights have gone off after the car door has been closed. Since the circuit must be operated by the door switch, a slight intervention in the wiring of this switch is unavoidable. When the car door is opened, the door switch closes the lights circuit to earth. When the door is closed (and the switch is open), transistor T1, whose base is linked to the switch, cuts off T2, so that the interior light remains off. When the switch closes (when the door is opened), the base of T1 is at earth level and the transistor is off.

Circuit diagram:

Capacitor C1 is charged fairly rapidly via R3 and D1, whereupon T2 comes on so that the interior light is switched on. When the door is closed again, T1 conducts and stops the charging of C1. However, the capacitor is discharged fairly slowly via R5, so that T2 is not turned off immediately. This ensures that the interior light remains on for a little while and then goes out slowly. The time delays may be varied quite substantially by altering the values of R3, R5, and C1. Circuit IC2 may be one of many types of n-channel power MOSFET, but it should be able to handle drain-source voltages greater than 50 V. In the proto-type, a BUZ74 is used which can handle D-S voltages of up to 500 V.
ReadMore....

Saturday, April 13, 2013

Outdoor LED Solar Lights Circuit Schematic

This Outdoor LED Solar Garden Lights venture is a passion circuit of an computerized garden mild the use of a LDR and 6V/5W solar panel. During day time, the internal rechargeable 6 Volt SLA battery receives charging current from the linked sun panel thru polarity safety diode D9 and current restricting resistor R10. If ambient light is commonplace, transistor T1 is reverse biased through IC1 (LM555). Here IC1 is wired as a medium current inverting line forcer, changeed by using an encapsulated light detector (10mm LDR). Multi-turn trimpot P1 sets the detection sensitivity. When ambient gentle dims, transistor T1 turns on to force the white LED string (D1-D8). Now this lamp load on the output of T1 energizes. Resistors R1-R8 limits the running current of the LEDs. When the ambient mild level restores, circuit returns to its idle state and light(s) changeed off by way of the circuit.

Circuit diagram:
Outdoor Garden Solar Lights Circuit Diagram

Assemble the Outdoor Solar Lights circuit on a basic function PCB and enclose the entire meeting in a transparent plastic box. Drill appropriate gaps on the highest of the enclosure to mount the mini sun panel (SP1) and the solarshine sensor (LDR), and in front for fitting power switch (S1) and the sensitivity controller (P1). Fix the battery within the cabinet the use of a double-sided glue tape/pad. Finally, the LDR will have to no longer be mounted to receive direct sunlight. It must be established on the prime of the enclosure, pointing to the sky say southwards. This circuit could be very simple. So and skilled pastimeists can alter/modify the entire circuit as per their very own ideas with none problem (Just are trying a 6V relay with T1 to force extra number of LED strings).


http://www.ecircuitslab.com/2011/10/outdoor-led-solar-lights-circuit.html
ReadMore....