Friday, January 10, 2014
Inverter as High Voltage low Current Source Circuit Diagram
The Inverter as High Voltage low Current Source Circuit Diagram is capable of providing power for portable Geiger counters, dosimeter chargers, high resistance meters, etc. The 555 timer IC is used in its multivibrator mode, the frequency adjusted to optimize the transformer characteristics.
When the output of the IC is high, current flows through the limiting resistor, the primary coil to charge C3. When the output is low, the current is reversed. With a suitable choice of frequency and C3, a good symmetric output is sustained.
Inverter as High Voltage low Current Source Circuit Diagram
Precise FM Tuning Indicator
Here is an add on circuit to your FM radio for precise tuning of stations. Usually an LED indicator is provided in FM radio to see whether the station is tuned or not. But it is difficult to see the precise tuning points since the variation in the LED brightness cannot be detected easily. This circuit solves the problem.
Precise FM Tuning Indicator Circuit diagram :
The circuit uses the Op Amp IC CA3140 as a differential amplifier to sense the voltage level between the terminals of the tuning LED. The output of IC1 drives two LEDs one Red and one Green to indicate whether the station is precisely tuned or not. If both LEDs remain off, it indicates precise tuning. If anyone LED is on, it indicates that tuning is not precise. If both LEDs remain on, it indicates that there is no signal.
First tune the FM receiver in a station having strong signal. The tuning LED will light brilliantly. Then connect point A and B to the soldering points of the tuning LED observing polarity. Adjust VR till both the Red and Green LEDs turn off. Slowly change the tuning knob position. Any one LED will light up. So the circuit is working. Now glue the wiper of VR using adhesive to prevent its position change. Disconnect the tuning LED from the board. Now the circuit is ready to use. Power for the circuit can be obtained from the power supply of FM radio.
Source : http://www.ecircuitslab.com/2012/08/fm-tuning-indicator-circuit.html
Thursday, January 9, 2014
Simple Low Power Switching Regulator Circuit Diagram
This is the Simple Low Power Switching Regulator Circuit Diagram. A simple battery-powered switching regulator provides 5 V out from a 9-V source with 80% efficiency and 50 mA output capability. When Q1 is on, its collector voltage rises, forcing current through the inductor. The output voltage rises, causing A1`s output to rise.
Low Power Switching Regulator Circuit Diagram
Q1 cuts off and the output decays through the load. The 100-pF capacitor ensures clean switching. The cycle repeats when the output drops1ow enough for A1 to turn on Ql. The 1-
230V LED Circuit Diagram
I think this circuit is very important circuit .because you can fix this circuit with a 230V switch or plug at that time you can see whether power is available or not.Not only that we can fix this circuit with door bells.In my home also I have attached this circuit with my door bell.
Note
If you are a student please dont try to make this because 230V is dangerous
Subscribe to:
Posts (Atom)